Re: Need advice on 97 R11RT

[Mick <bmwmick@xxxxxxxxxxx>]

At 04:12 PM 4/21/2005 -0700, you wrote:
>At 06:05 PM 4/21/2005 -0400, Tpcutter@xxxxxxx wrote:
>>Dave-
>>
>> From the BMW manual:
>>
>>Tightening  torque/tightening sequence: INITIAL ASSEMBLY ONLY
>>1. Tighten cylinder head  nuts (oiled) in diagonally
>>opposite sequence
>>1.1 Tighten all  nuts....................................... 20 Nm
>>1.2 Tighten all nuts to  correct angle .................. 90:
>>1.3 Tighten all nuts to correct angle  .................. 90:
>>2. M 10 screw  ............................................ 40 Nm    (the one
>>in  the cam chain tunnel)
>>
>>3. M 6 screw  ................................................ 9 Nm   (THESE
>>are the  TORX screws!)
>>
>>
>>Tightening torque:
>>Retighten after 1000 km  (app. 600 miles)
>>Tighten cylinder head nuts in diagonally  opposite
>>sequence
>>1. Slacken one nut
>>2. Tighten nut to initial  torque...................... 20 Nm
>>3. Tighten nut to wrench  angle...................... 180:
>>4. Slacken and retighten M10  screw........... 40 Nm
>>
>>
>>
>>Tom Cutter
>>Yardley, PA
>>"What's the  point of being stupid if you're not going to show it?"
>>Rubber Chicken Racing  Garage Apparel coming VERY soon. Inquire here.
>
>I added the 'degree' symbols.  ALT+0186  FYI.  No confusion now. : ))
>
>Mick
>Tucson

How weird, the Character : (the degree symbol) gets converted to a : here. ????

Mick
Tucson

------------------------------